Quick Start Guide

User Manual of PanoVu Series Network Camera
101
Figure 7-15 Modify an IP
(3) Click OK to finish modifying.
 Delete an IP Address
Left-click an IP address from filter list and click Delete.
 Delete all IP Addresses
Click Clear to delete all the IP addresses.
5. Click Save to save the settings.
7.3.3 Configuring Security Service Settings
Steps:
1. Enter the Security Service interface:
Configuration> System > Security > Security Service
2. Check the Enable Illegal Login Lock checkbox to automatically lock the device IP after performing 5
failed password attempts.
7.4 User Management
Enter the User Management interface:
Configuration > System > User Management
 As Administrator
The administrator can add, delete or modify user accounts, and grant them different permissions. We
highly recommend administrator to manage the device accounts and user permissions properly. Up to
31 user accounts can be created.
Administrator need to input correct admin password when changing settings of other operators or
users.
Administrator can set Security Question. Security question is used to reset the forgotten password.
When resetting the forgotten password, the PC the administrator uses and the camera should belong to
the same IP address segment of the same LAN.
 As Operator or User
Operator or user can modify password. Old password is required for this action.
 Password Recommendation
The system judges the password strength automatically when creating the password. A strong
password is highly recommended to ensure your data security. And a strong password should be your
own choosing (using a minimum of 8 characters, including at least three of the following categories:
upper case letters, lower case letters, numbers, and special characters).
Online User
Enter the Online Users configuration interface:
Configuration > System > User Management > Online Users