Quick Start Guide
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Rapid Focus
- Chapter 5 Storage and Playback
- Chapter 6 Events Settings
- Chapter 7 System Settings
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
34
Manual:
In Manual mode, you need to use on the control panel to focus manually.
Min. Focus Distance
This function is used to limit the minimum focus distance.
Note:
Focus settings applies only to PTZ camera channel.
Day/Night Switch
Day/Night Switch
The Day/Night Switch mode can be set to Auto, Day, Night, and Scheduled-Switch.
Auto:
In Auto mode, the day mode and night mode can switch automatically according to the light
condition of environment. The switching sensitivity can be set to Low, Normal, High.
Figure 3-9 Auto Mode Sensitivity
Day:
In Day mode, the camera displays color image. It is used for normal lighting conditions.
Night:
In Night mode, the image is black and white. Night mode can increase the sensitivity in low light
conditions.
Scheduled-Switch
In Scheduled-Switch mode, you can set the time schedule for day mode as shown in Figure 3-10.
The rest time out of the schedule is for night mode.
Figure 3-10 Day Night Schedule
Smart Supplement Light
If the light supplement is on and the image center is overexposure, you can enable this function.
IR Light Mode
IR light mode can be set to Auto and Manual.
Auto: The brightness of the infrared light will be adjusted automatically. IR Light Sensitivity
value ranges from 0 to 100. Trigger Mode can be set to Camera or Photosensitive.
Manual: you need to adjust the brightness value of infrared light manually. Brightness Limit
value ranges from 0 to 100.
Notes:
This function varies depending on different camera models.
The IR related functions are supported by the IR camera only.
For detailed parameters configuration of IR light, you can enter the OSD menu by calling the special
preset 95.