Quick Start Guide
Table Of Contents
- About This Document
- Chapter 1 Activating and Accessing to the Camera
- Chapter 2 Setting Local Parameters and Network
- Chapter 3 Live View
- Chapter 4 PTZ Control
- 4.1 Operating PTZ Control
- 4.2 PTZ Configuration
- 4.2.1 Configuring Basic PTZ Parameters
- 4.2.2 Configuring PTZ Limits
- 4.2.3 Configuring Initial Position
- 4.2.4 Configuring Park Action
- 4.2.5 Configuring Privacy Mask
- 4.2.6 Configuring Scheduled Tasks
- 4.2.7 Clearing PTZ Configurations
- 4.2.8 Configuring PTZ Control Priority
- 4.2.9 Configuring Panorama Tracking
- 4.2.10 Rapid Focus
- Chapter 5 Storage and Playback
- Chapter 6 Events Settings
- Chapter 7 System Settings
- Appendix
- Appendix 1 SADP Software Introduction
- Appendix 2 Statics, Interference Lightning and Surge Protection
- Appendix 3 Waterproof
- Appendix 4 Bubble Maintenance
- Appendix 5 RS-485 Bus Connection
- Appendix 6 24VAC Wire Gauge & Transmission Distance
- Appendix 7 12VDC Wire Gauge & Transmission Distance
- Appendix 8 Table of Wire Gauge Standards
- Appendix 9 Alarm In/Out Connections
- Appendix 10 Camera Function Description
User Manual of PanoVu Series Network Camera
88
Figure 6-24 Draw Area
4) Enable rules: Check the Enable checkbox of each rule in the rule list to enable the rule.
5) Click to save the settings.
Region Exiting
Purpose:
This function can be used for detecting people, vehicles and objects exiting the pre-defined region.
The alarm will be triggered if the rule is broken.
Steps:
1) Create new rule: Click to add a new rule.
2) Select rule type: Click the dropdown list and select Region Exiting as the rule type.
Figure 6-25 Select Rule Type
3) Configure the rule area:
Click on the tool bar of the live view panel. Click the mouse on the live view panel. Right
click the mouse to finish drawing.