User Manual

User Manual of Network Positioning System

Chapter 2 Network Connection

 You shall acknowledge that the use of the product with Internet access might be under

network security risks. For avoidance of any network attacks and information leakage,

strengthen your own protection. If the product does not work properly, contact with your

dealer or the nearest service center.

 To ensure the network security of the network positioning system, we recommend you to

have the network positioning system assessed and maintained termly. You can contact us if

you need such service.

Before you start:

 If you want to set the network positioning system via a LAN (Local Area Network), refer to

Section 2.1 Setting the Network Positioning System over the LAN.

 If you want to set the network positioning system via a WAN (Wide Area Network), refer to

Section 2.2 Setting the Network Positioning System over the WAN.

2.1 Setting the Network Positioning System over the

LAN

Purpose:

To view and configure the network positioning system via a LAN, you need to connect the

network positioning system in the same subnet with your computer, and install the SADP or client

software to search and change the IP of the network positioning system.

For the detailed introduction of SADP, refer to Appendix.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network positioning system and

a computer:

Purpose:

 To test the network positioning system, you can directly connect the network positioning

system to the computer with a network cable as shown in Figure 2-1.

 Refer to the Figure 2-2 to set the network positioning system over the LAN via a switch or a

router.