User Manual

User Manual of Network Positioning System

This network positioning system supports the PPPoE auto dial-up function. The network

positioning system gets a public IP address by ADSL dial-up after the network positioning system

is connected to a modem. You need to configure the PPPoE parameters of the network

positioning system. Refer to Section 6.1.1 Configuring PPPoE Settings for detailed configuration.

The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes after

rebooting the network positioning system. To solve the inconvenience of the dynamic IP, you

need to get a domain name from the DDNS provider (E.g. DynDns.com). Follow the steps below

for normal domain name resolution and private domain name resolution to solve the problem.

 Normal Domain Name Resolution

Steps:

1. Apply a domain name from a domain name provider.

2. Configure the DDNS settings in the DDNS Settings interface of the network positioning

system. Refer to Section 6.1.1 Configuring DDNS Settings for detailed configuration.

3. Visit the network positioning system via the applied domain name.