User Manual

User Manual of Network Positioning System
© Hikvision
39
5.2 Basic Event Configuration
Purpose:
This section explains how to configure the network positioning system to respond to alarm
events, including motion detection, video tampering alarm input, alarm output and exception.
These events can trigger the alarm actions, such as Send Email, Notify Surveillance Center, etc.
For example, when motion detection is triggered, the network positioning system sends a
notification to an e-mail address.
 On the event configuration page, click to show the PTZ control panel or click to hide it.
 Click the direction buttons to control the pan/tilt movements.
 Click the zoom/iris/focus buttons to realize lens control.
 The functions vary depending on different positioning system models.
5.2.1 Configuring Motion Detection
Purpose:
Motion detection is a feature which can trigger alarm actions and actions of recording videos
when the motion occurred in the surveillance scene.
Steps:
1. Enter the motion detection setting interface:
Configuration > Event > Basic Event > Motion Detection
2. Check the checkbox of the Enable Motion Detection to enable this function.
You can check the Enable Motion Detection in PTZ Control checkbox and when the network
positioning system is performing PTZ action, motion detection can also trigger alarm.
You can check the Enable Dynamic Analysis for Motion checkbox if you want the detected
object get marked with rectangle in the live view.
3. Select the configuration mode as Normal or Expert and set the corresponding motion
detection parameters.
 Normal