User Manual

User Manual of Network Positioning System
© Hikvision
72
You can use SNMP to get network positioning system status and parameters related information.
Before you start:
Before setting the SNMP, use the SNMP software and manage to receive the network positioning
system information via SNMP port. By setting the Trap Address, the network positioning system
can send the alarm event and exception messages to the surveillance center.
The SNMP version you select should be the same as that of the SNMP software.
Steps:
1. Enter the SNMP settings interface:
Configuration > Network > Advanced Settings > SNMP
Figure 6-7 SNMP Settings
2. Check the corresponding version checkbox (Enable SNMP v1, Enable SNMP v2c, Enable
SNMP v3) to enable the feature.
3. Configure the SNMP settings.
The configuration of the SNMP software should be the same as the settings you configure