User Manual

User Manual of Network Positioning System
© Hikvision
81
3. Check the Enable IEEE 802.1X checkbox to enable it.
4. Configure the 802.1X settings, including user name and password.
The EAP-MD5 version must be identical with that of the router or the switch.
5. Click to finish the settings.
The network positioning system reboots when you save the settings.
6. After the configuration, connect the network positioning system to the protected network.
Integration Protocol
Purpose:
If you need to access to the network positioning system through the third party platform, you can
enable Hikvision-CGI function. And if you need to access to the device through ONVIF protocol,
you can configure ONVIF user in this interface. Refer to ONVIF standard for detailed configuration
rules.
Steps:
1. Enter the Integration Protocol configuration interface.
Configuration > Network > Advanced Settings > Integration Protocol
Figure 6-19 Integration Protocol Settings
2. Check the Enable Hikvision-CGI checkbox and then select the authentication from the
dropdown list. Then you can access to the network positioning system through the third party
platform.
3. Check the Enable ONVIF checkbox to enable the function.