User's Manual

Thermal & Optical Network Turret Camera Quick Start Guide

3 Install the Turret Camera

Before you start:

1. Check the package contents and make sure that the device in the package is in good

condition and all the assembly parts are included.

2. Please turn off the power of the Turret Camera before connecting the cables.

Notes:

 Do not drag the Turret Camera with its waterproof cables, or the waterproof

performance is affected.

 Please remove the protective film on the Turret after the installation.

 Do not touch the bubble of the lower Turret directly. The image blurs otherwise.

3.1 Monitor Distance Range

Electric lens is adopted for the thermal channel of Turret Camera. It supports auto-focus

function and remote focus function. For different lens focal length, the monitoring

range is shown in the table below:

Table 3-1 Monitor Range (Pixel Interval: 17um)

Lens Focal Length/mm

1.8

3.1

6.2

MRAD

9.44

5.48

2.83

Detection Range (Vehicle)/m

162

280

559

Detection Range (Human)/m

182

Recognition Range (Vehicle)/m

140

Recognition Range (Human)/m

Identification Range (Vehicle)/m

Identification Range (Human)/m

Notes:

 This table is for reference only, and the actual detection range may vary according

to different camera settings, mounting condition, monitor and so on.

 When the weather is fine and the atmospheric visibility is normal, the probability of

detecting/recognizing/identifying target is 50%.

 The human width is presumed as 0.5m (human width cannot exceed 0.75m), the

human height is presumed as 1.8m, and the vehicle width cannot exceed 2.3m.