User's Manual

Thermal & Optical Network Turret Camera Quick Start Guide
4
your supplier or to a designated collection point. For more information see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to
avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
Warnings: Neglecting any of the warnings may cause serious injury or death.
Cautions: Neglecting any of the cautions may cause injury or equipment damage.
Warnings
 The device should be used in compliance with local laws and electrical safety
regulations. Refer to the appropriate documentation for detailed information.
 The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low
Voltage) and the Limited Power Source (12 VDC). Refer to the appropriate
documentation for detailed information.
 DO NOT connect multiple devices to one power adapter, to avoid over-heating or
fire hazards caused by overload.
 Make sure the plug is properly connected to the power socket.
 If smoke, odor, or noise arises from the device, immediately turn off the power,
unplug the power cable, and contact the service center.
 The installer and user are responsible for password and security configuration and
its settings.
 Both internal and external grounds should be connected properly. (The cross section
area of the grounding wire must be no less than 4 mm
2
, and no less than that of the
phase connector).
Cautions
 Do not drop the device or subject it to physical shock.
 Wipe the device gently with a clean cloth and a small quantity of ethanol, if
necessary.
 Do not aim the lens at the sun or any other bright light.
Warnings Follow these safeguards to
prevent serious injury or death.
Cautions Follow these precautions to prevent
potential injury or material damage.