User's Manual

Chapter 6 Event and Alarm
This part introduces the conguraon of events. The device takes certain response to triggered
alarm.
6.1 Set Moon Detecon
It helps to detect the moving objects in the detecon region and trigger the linkage acons.
Steps
1. Go to Conguraon → Event → Basic Event → Moon Detecon .
2. Select the channel No.
3. Check Enable
Moon Detecon.
4. Oponal: Highlight to display the moving object in the image in green.
1) Check Enable Dynamic Analysis for
Moon.
2) Go to Conguraon → Local .
3) Set Rules to Enable.
5. Select
Conguraon Mode, and set rule region and rule parameters.
-
For the
informaon about normal mode, see Normal Mode .
-
For the informaon about expert mode, see Expert Mode .
6. Set the arming schedule and linkage methods. For the informaon about arming schedule
sengs, see Set Arming Schedule . For the informaon about linkage methods, see Linkage
Method Sengs .
7. Click Save.
6.1.1 Normal Mode
You can set moon detecon parameters according to the device default parameters.
Steps
1. Select normal mode in Conguraon.
2. Set the
sensivity of normal mode. The higher the value of sensivity is, the more sensive the
moon detecon is. If the sensivity is set to 0, moon detecon and dynamic analysis do not
take
eect.
3. Click Draw Area. Click and drag the mouse on the live video, then release the mouse to nsh
drawing one area.
Thermal & Opcal Bi-spectrum Network Camera User Manual
22