User's Manual

Figure 6-2 Set Rules
Stop Drawing Finish drawing one area.
Clear All Delete all the areas.
4. Oponal: Repeat the above steps to set mulple areas.
6.2 Set Video Tampering Alarm
When the congured area is covered and cannot be monitored normally, the alarm is triggered and
the device takes certain alarm response
acons.
Steps
1. Go to
Conguraon → Event → Basic Event → Video Tampering .
2. Select the channel number.
3. Check Enable.
4. Set the
Sensivity. The higher the value is, the easier to detect the area covering.
5. Click Draw Area and drag the mouse in the live view to draw the area.
Stop Drawing
Finish drawing.
Clear All Delete all the drawn areas.
Thermal & Opcal Bi-spectrum Network Camera User Manual
24