User's Manual

7.2.4 Nofy Surveillance Center
Check Nofy Surveillance Center, the alarm informaon is uploaded to the surveillance center
when an alarm event is detected.
7.2.5 Trigger Recording
Check Trigger Recording, and the device records the video about the detected alarm event.
For device with more than one camera channels, you can set one or more channels to take
recordings if needed.
For recording
sengs, refer to Video Recording and Picture Capture
7.2.6 Set Audible Alarm Output
For device that supports audible warning as a linkage method, opons are open to congure
audible alarm parameters.
Steps
Note
The funcon is only supported by certain camera models.
1. Go to the seng page: Conguraon → Event → Basic Event → Audible Alarm Output .
2. Select desired alarm sound type and alarm mes.
3. Set arming schedule for audible alarm. Refer to Set Arming Schedule
4. Click Save.
7.2.7 Set Flashing Alarm Light Output
Steps
1. Go to Conguraon → Event → Basic Event → Flashing Alarm Light Output .
2. Set Flashing Duraon, Flashing Frequency and Brightness.
Flashing
Duraon
The me period the ashing lasts when one alarm happens.
Flashing Frequency
The ashing speed of the light. High, Medium, and Low are selectable.
Brightness
The brightness of the light.
3. Edit the arming schedule.
4. Click Save.
Thermal & Opcal Bi-spectrum Network Camera User Manual
31