User's Manual

Register status turns to Online when the funcon is correctly set.
11.10 Set ONVIF
If you need to access to the device through ONVIF protocol, you can congure the ONVIF user to
enhance the network security.
Steps
1.
Go to Conguraon → Network → Advanced Sengs → Integraon Protocol .
2. Check Enable ONVIF.
3. Click Add to
congure the ONVIF user.
Delete Delete the selected ONVIF user.
Modify Modify the selected ONVIF user.
4. Click Save.
5.
Oponal: Repeat the steps above to add more ONVIF users.
11.11 Set HTTP Listening
The device can send alarms to desnaon IP or host name through HTTP protocol. The desnaon
IP or host name should support the HTTP data transmission
Steps
1. Go to Conguraon → Network → Advanced Sengs → HTTP Listening .
2. Input Desnaon IP or Host Name, URL, and Port.
3. Click Test.
Note
Click Default to reset the desnaon IP or host name.
4. Click Save.
Thermal & Opcal Bi-spectrum Network Camera User Manual
64