Quick Start Guide

Thermal Network Speed Dome Quick Start Guide
7
Waterproof Measures (Optional)
Purpose:
If the camera is installed outdoor, you should use the waterproof accessory or tapes to
waterproof the cables. Otherwise the cables might get wet or a short circuit might occur.
Install Network Cable Waterproof Jacket
⑥
④
②
③
①
④
⑤
⑥
③
①
Align
Figure 1-3 Install Waterproof Jacket
Steps:
1. Feed the network cable through ① and ③ in order.
2. Fix ② on the network cable between ① and ③.
3. Place ⑤ onto the end of ⑥, and plug the RJ45 male connector into RJ45 female
connector.
4. Screw ③ to ⑥ clockwise.
5. Push ② into ③.
6. Secure ① with the ③ in clockwise direction.
Waterproof Other Cables
After routing and connecting the cables, use the waterproof tapes to wrap up the cables.
Connected cables and spare cables both should be wrapped up as the figures below.
Figure 3-1 Waterproof Cable