User Manual

User Manual of Thermal Network Speed dome
© Hikvision
100
Figure 7-26 Basic PTZ Configuration Interface
2. Configure the following settings:
 Basic Parameters: Enable/disable proportional pan and preset freezing, set the preset
speed, keyboard control speed, and auto scan speed.
 Proportional Pan: If you enable this function, the pan/tilt speeds change according
to the amount of zoom. When there is a large amount of zoom, the pan/tilt speed
will be slower for keeping the image from moving too fast on the live view image.
 Preset Freezing: This function enables the live view to switch directly from one
scene defined by a preset to another, without showing the middle areas between
these two, to ensure the surveillance efficiency. It can also reduce the use of
bandwidth in a digital network system.
Preset freezing function is invalid when you calling a pattern.
 Preset Speed: You can set the speed of a defined preset from 1 to 8.
 Manual Control Speed: The speed dome provides 5 control speed modes:
Compatible, Pedestrian, Non-motor Vehicle, Motor Vehicle and Auto. Select it from
the dropdown list.
 Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low,
Medium or High.
 Auto Scan Speed: The scan speed can be set from level 1 to 40.
 Max. Tilt-angle: Set the tilt-angle of the speed dome from the dropdown list.
 Zooming Speed: The speed of zooming is adjustable.
 PTZ OSD: Set the on-screen display duration of the PTZ status.
 Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds, 10
seconds, Always Close or Always Open.
 PT Status: Set the azimuth angle display duration while panning and tilting as 2
seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Position Display Format: Set the position display format as PT or Direction and the
position parameter displays in corresponding format.
 Preset Status: Set the preset name display duration while calling the preset as 2
seconds, 5 seconds, 10 seconds, Always Close or Always Open.
 Power-off Memory: The speed dome can resume its previous PTZ status or actions
after it restarted from a power-off. You can set the time point of which the speed
dome resumes its PTZ status. You can set it to resume the status of 30 seconds, 60
seconds, 300 seconds or 600 seconds before power-off.
3. Click to save the settings.
7.3.2 Configuring PTZ Limits
Purpose:
The speed dome can be programmed to move within the configurable PTZ limits