User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Speed dome Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 PTZ Configuration
- 7.4 Configuring Image Settings
- 7.5 Configuring System Settings
- Appendix
User Manual of Thermal Network Speed dome
© Hikvision
107
Figure 7-35 Position Settings
2. Set the vandal-resistance alarm.
(1) Slide the bar to adjust the sensitivity of vandal-resistance detection.
(2) Check the checkbox of Upload Vandal-Resistance Alarm to upload the
vandal-resistance alarm.
(3) Check the checkbox of Enable Vandal-Resistance Alarm Voice Warning to enable
the voice warning of vandal-resistance alarm.
3. Set GPS settings.
(4) Select Longitude-Latitude Mode as Manual.
(5) Select longitude and latitude as East or West according to the actual position.
(6) Enter the value of longitude and latitude in three textboxes.
4. Click to save the settings.
7.3.9 Configuring Linear Scan
Steps:
1. Get to the linear scan interface:
Configuration > Advanced Configuration> PTZ > Linear Scan.
Figure 7-36 Linear Scan
2. Select Camera 1 or Camera 2 from the Channel No. list.
3. Zoom in and zoom out the camera to the appropriate zoom ratio.
4. Click Save Ratio to save the zoom ratio.