User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Speed dome Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 PTZ Configuration
- 7.4 Configuring Image Settings
- 7.5 Configuring System Settings
- Appendix
User Manual of Thermal Network Speed dome
© Hikvision
124
Steps:
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It
can be set from 1 to 10080 minutes.
Figure 7-58 Time Sync by NTP Server
You can click to make sure that the NTP server is connected.
If the speed dome is connected to a public network, you should use a NTP server that
has a time synchronization function, such as the server at the National Time Center
(IP Address: 210.72.145.44). If the speed dome is set in a customized network, NTP
software can be used to establish a NTP server for time synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click to set the system time from the pop-up calendar.
(3) Click to save the settings.
You can also check the Sync with local time checkbox to synchronize the time of the
speed dome with the time of your computer.
Figure 7-59 Time Sync Manually