User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Speed dome Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 PTZ Configuration
- 7.4 Configuring Image Settings
- 7.5 Configuring System Settings
- Appendix
User Manual of Thermal Network Speed dome
© Hikvision
126
Figure 7-62 RS-485 Settings
2. Set the RS-485 parameters and click to save the settings.
The Baud rate, PTZ Protocol and PTZ Address parameters of the speed dome should be
exactly the same as those of the control device.
7.5.2 Maintenance
Upgrade & Maintenance
Rebooting the Positioning system
Steps:
1. Enter the Maintenance interface:
2. Configuration > System > Maintenance > Upgrade & Maintenance:
3. Click Reboot to reboot the network positioning system.
Restoring Default Settings
Steps:
1. Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance:
2. Click Restore or Default to restore the default settings.
Clicking Default to restores all the parameters to default settings including the IP
address and user information. Please use this button with caution.