User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Speed dome Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 PTZ Configuration
- 7.4 Configuring Image Settings
- 7.5 Configuring System Settings
- Appendix
User Manual of Thermal Network Speed dome
© Hikvision
50
Figure 5-16 Alarm Input Settings
4. Click tab to enter the arming schedule setting interface. The
arming schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Section 5.2.1 Configuring Motion Detection.
5. Click tab to select the linkage method taken for alarm input,
including Notify Surveillance Center, Send Email, Upload to FTP/Memory Card/NAS,
Trigger Alarm Output and Trigger Recording. Refer to Section 5.2.1 Configuring Motion
Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative checkbox
and select the No. to enable Preset Calling, Patrol Calling or Pattern Calling.
7. You can copy your settings to other alarm inputs.
8. Click to save the settings.
Figure 5-17 Linkage Method