User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Speed dome
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Speed dome Configuration
- 7.1 Configuring Network Settings
- 7.2 Configuring Video and Audio Settings
- 7.3 PTZ Configuration
- 7.4 Configuring Image Settings
- 7.5 Configuring System Settings
- Appendix
User Manual of Thermal Network Speed dome
© Hikvision
69
the minimum target size.
Displacement Constraint for Target Generation: Range [0-4], the higher the value is,
the slower the target is generated, and the higher accuracy the analysis will get.
Scene Modes: The scene mode is set to be General by default. Select Distant View
when you are far from the targets. Select Indoor when you are indoor.
Optical-axis Movement: Check the checkbox when the target moves in the direction of
camera's optical -axis.
Single Alarm: You can enable Single Alarm, and the system only sends alarm once for
one target triggering. Otherwise, the alarm will be triggered continuously until the
target disappears.
3. Adjust the Tracking Parameters.
Post-Tracking: Range [2-600], you can configure the tracking duration after the target
is still.
Restore Default: Click Restore to restore the parameters to the default.
Restart VCA: Click Restart to restart the VCA function.
6.3 Behavior Analysis
Purpose:
The speed dome supports patrol tracking for multiple scenes. At most 8 rules can be
configured for a single scene. You can configure the rules for the scene on your demand.
Steps:
1. Configure the VCA Info: For details, see 7.2 Configuring VCA Information.
2. Configure the Zooming Ratio parameters: Set the appropriate tracking zooming ratio
with the PTZ control panel. Click on to save the settings.
The optical camera will track the target when the VCA rule is triggered which is
configured on the thermal camera.