User Manual

User Manual of Thermal Network Speed dome
© Hikvision
71
the tracking duration will not be limited.
Limited Tracking: You can check the checkbox to enable/disable the function. If
the function is enabled, you can set the limited position for the tracking.
4) Click to save the settings.
 Rule Configuration:
At most 8 rules can be configured for a single scene. Follow the steps below to
configure the rule for the scene.
1) Click the Rule tab to enter the rule settings interface.
2) Create new rule: Click on the button to add a new rule.
3) Select rule type: Click the dropdown menu to select the rule type. Line Crossing,
Intrusion, Region Entrance, and Region Exiting are selectable.
Figure 6-5 Rule List
4) Configure the rule area: Click the Draw Line or Draw Area button on the tool bar of
the live view panel. Click the mouse on the live view panel. Right click the mouse
to finish drawing. For details, see 6.4 Rule Configuration Demonstration.
5) Configure the filtering size: The filtering function is supported for all rules. You
can set the minimum and maximum size of the object needs to be filtered. The
system will only detect the object in a size between the configured minimum and
maximum value. For details, see6.4 Rule Configuration Demonstration.
6) Configure the Duration: Set the dwell time of the target cross the line or area. The
intelligent analysis will be enabled during the period.
7) Configure the Sensitivity: The higher the value is, more easily the alarm will be
triggered.
8) Configure the Detection Target.
9) Enable rules: Check the Enable checkbox of each rule in the rule list to enable the
rule.
10) Click to save the settings.
Create multiple rules: You can create more rules by repeating the above steps.
 Configure Arming schedule:
1) Click the Arming Schedule tab.
2) Select a rule from the rule list.