User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
99
Figure 7-7 Port Mapping Mode
4. Click .
Configure Multicast Settings
Purpose:
Multicast is group communication where data transmission is addressed to a group of destination
devices simultaneously.
Figure 7-8 Set Multicast
Steps:
1. Go to the Multicast setting interface: Configuration > Network > Basic Settings > Multicast.
2. Select the channel number.
3. Set IP Address, Stream Type, Video Port, and Audio Port of the camera.
Notes:
• IP Address stands for the address of multicast.
• Video port and audio port of each video stream of each camera channel can be specified by
selecting a stream in Video Stream and inputting port number in Video Port and Audio Port.
4. Click Save.