User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
100
7.1.2 Advanced Settings
Configure SNMP
Purpose:
You can use SNMP to get device status and parameters related information.
Before you start:
Before setting the SNMP, please use the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the device can send the alarm event and
exception messages to the surveillance center.
The SNMP version you select should be the same as that of the SNMP software.
Steps:
1. Go to the. SNMP settings interface:
Configuration > Network > Advanced Settings > SNMP
Figure 7-9 SNMP Settings
2. Check Enable SNMP v1, Enable SNMP v2c, or Enable SNMP v3 to enable the feature.