User Manual

User Manual of Thermal Bi-spectrum Network PTZ Device
108
3. Check Enable IEEE 802.1X.
4. Configure the 802.1X settings, including user name and password.
The EAP-MD5 version must be identical with that of the router or the switch.
5. Click .
The camera reboots when you save the settings.
6. After the configuration, connect the camera to the protected network.
Integration Protocol
Purpose:
If you need to access to the camera through the third party platform, you can enable CGI function.
And if you need to access to the device through ONVIF protocol, you can configure ONVIF user in
this interface. Refer to ONVIF standard for detailed configuration rules.
 CGI
Check Enable Hikvision_CGI and then select the authentication from the drop-down list.
Digest is the recommended authentication method.
 ONVIF
Steps:
1. Check Enable ONVIF to enable the function.
2. Add ONVIF users. Up to 32 users are allowed.
3. Set the user name and password, and confirm the password. You can set the user as media
user, operator, and administrator.
ONVIF user account is different from the camera user account. You have set ONVIF user account
independently.
4. Save the settings.
User settings of ONVIF are cleared when you restore the camera.
7.2 Configure Video and Audio Settings
7.2.1 Configure Video Settings
Steps:
1. Go to the. Video settings interface:
Configuration > Video/Audio > Video