User Manual

ManualsBrandsHikvision ManualsPT seriesThermal & Optical Bi-spectrum Network Stable PTZ Camera

Table Of Contents

Chapter 1 Overview
Chapter 2 Network Connection
- 2.1 Set the Network Device over the LAN
  - 2.1.1 Wiring over the LAN
  - 2.1.2 Activate the Device
- 2.2 Set the Network Device over the WAN
  - 2.2.1 Static IP Connection
  - 2.2.2 Dynamic IP Connection
Chapter 3 Access to the Network Device
Chapter 4 Basic Operations
Chapter 5 System Configuration
Chapter 6 VCA Configuration
Chapter 7 Device Configuration
Appendix
- Appendix 1
- Appendix 2

User Manual of Thermal Bi-spectrum Network PTZ Device 
6 
 
 
Figure 1-5 Draw the Privacy Mask 
2.  Click the PTZ control buttons to find the area you want to set the privacy mask. 
3.  Click ; click and drag the mouse in the live video window to draw the area. 
4.  You can drag the corners of the red rectangle area to draw a polygon mask. 
5.  Click    to finish drawing or click    to clear all of the areas you set without 
saving them. 
6.  Click    to save the privacy mask, and it will be listed in the Privacy Mask List area; set 
the value of Active Zoom Ratio on your demand, and then the mask will only appear when 
the zoom ratio is greater than the predefined value. 
 
Figure 1-6 Privacy Mask List 
7.  Check Enable Privacy Mask. 
 
You are allowed to draw up to 8 areas for the device. 