User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
124
5. Check Enable Picture Overlay.
6. Set X Coordinate and Y Coordinate values adjust the picture position on the image.
Adjust picture width and picture height to the desired size.
7. Click Save.
Note: The picture must be in RGB24 bmp format and the maximum picture size is 128*128.
7.3.6 Configure DPC Settings
DPC (Defective Pixel Correction) refers to the function that the camera can correct the defective
pixels on the LCD which are not performing as expected.
Figure 7-39 Defective Pixel Correction
Manual DPC Correction
Steps:
1. Select Manual from the modes.
2. Point to the defective pixel, and click to adjust the position.
3. Click to start correction.
4. (Optional) Click to cancel the correction.
This function varies depending on the models of device.
7.3.7 Picture in Picture
Purpose:
The system plays the live view of thermal channel and optical channel at the same time.
Steps:
1. Select the channel No. from the list.