User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
127
Steps:
(1) Enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It can be
set from 1 to 10080 minutes.
Figure 7-43 Time Sync by NTP Server
You can click to make sure that the NTP server is connected.
If the device is connected to a public network, you should use a NTP server that has a time
synchronization function, such as the server at the National Time Center (IP Address:
210.72.145.44). If the device is set in a customized network, NTP software can be used to
establish a NTP server for time synchronization.
Configure Time Synchronization Manually
Steps:
(1) Check Manual Time Sync.
(2) Click to set the system time from the pop-up calendar.
(3) Click .
You can also check Sync with local time to synchronize the time of the device with the time
of your computer.
Figure 7-44 Time Sync Manually
Select the Time Zone