User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
129
Figure 7-47 RS-232 Settings
2. Set the RS-232 parameters and click Save.
Configure RS-485
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
Steps:
1. Go to RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS-485
Figure 7-48 RS-485 Settings
2. Set the RS-485 parameters and click .
The Baud rate, PTZ Protocol and PTZ Address parameters of the device should be exactly the
same as those of the control device.