User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
134
Figure 7-57 VCA Information
2. Check to enable the VCA resource type.
3. The system reboots and the selected VCA resource will be enabled.
Once you select any of the resources, the other VCA rules cannot be enabled.
7.4.3 Security
Configure Authentication Security
Purpose:
You can specifically secure the stream data of live view.
Steps:
1. Go to the. Authentication interface:
Configuration> System> Security > Authentication
2. Set the authentication mode for each authentication type.
RTSP Authentication: Select the authentication mode as digest or basic/digest in the
dropdown list.
WEB Authentication: Select the authentication mode as digest or basic/digest in the
dropdown list.
3. Click .
Configure IP Address Filter
Purpose:
With this function on, the camera allows certain IP addresses whether to log in or not.
Steps:
1. Go to IP Address Filter interface:
Configuration > System > Security > IP Address Filter