User Manual

ManualsBrandsHikvision ManualsPT seriesThermal & Optical Bi-spectrum Network Stable PTZ Camera

Table Of Contents

Chapter 1 Overview
Chapter 2 Network Connection
- 2.1 Set the Network Device over the LAN
  - 2.1.1 Wiring over the LAN
  - 2.1.2 Activate the Device
- 2.2 Set the Network Device over the WAN
  - 2.2.1 Static IP Connection
  - 2.2.2 Dynamic IP Connection
Chapter 3 Access to the Network Device
Chapter 4 Basic Operations
Chapter 5 System Configuration
Chapter 6 VCA Configuration
Chapter 7 Device Configuration
Appendix
- Appendix 1
- Appendix 2

User Manual of Thermal Bi-spectrum Network PTZ Device 
9 
 
Figure 1-10 Position Settings 
2.  Select Network or RS-485 from the dropdown list 
3.  Set the delay time (Range 2-200s). 
4.  Click  . 
1.3.8  Position and Vandal-Resistance Alarm Settings 
Steps: 
1.  Go to the. Position Settings interface: 
Configuration > PTZ > Position Settings. 
 
The actual interface may vary from model to model. 
 
Figure 1-11 Position Settings 
2.  Set the vandal-resistance alarm. 
(1)  Slide the bar to adjust the sensitivity of vandal-resistance detection.   
(2)  Check Upload Vandal-Resistance Alarm to upload the vandal-resistance alarm. 
(3)  Check Enable Vandal-Resistance Alarm Voice Warning to enable the voice warning of 
vandal-resistance alarm.   