User Manual

User Manual of Thermal Bi-spectrum Network PTZ Device
10
3. Set GPS settings.
(1) Select Longitude-Latitude Mode as Manual.
(2) Select longitude and latitude as East or West according to the actual position.
(3) Input the value of longitude and latitude in three textboxes.
4. Click .
1.3.9 Configure Linear Scan
Steps:
1. Go to the linear scan interface:
Configuration > Advanced Configuration> PTZ > Linear Scan.
Figure 1-12 Linear Scan
2. Select Camera 1 or Camera 2 from the Channel No. list.
3. Zoom in and zoom out the camera to the appropriate zoom ratio.
4. Click Save Ratio.
5. Optionally, you can click Enable Saved Ratio to set the camera to the saved zoom ratio.
6. Click Set Scan Area and set the left/right/up/down limits with the PTZ control panel and
Iris+/- button.
7. Optionally, you can click Clear to delete the saved scan area.
8. Click Save and the Linear Scan Area shows Scan area saved.
9. Click Start Linear Scan and Stop Linear Scan to start and stop the saved linear scan.