User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
14
Chapter 2 Network Connection
Before you start:
If you want to set the network device via a LAN (Local Area Network), please refer to Section
2.1.
If you want to set the network device via a WAN (Wide Area Network), please refer to
Section 2.2.
2.1 Set the Network Device over the LAN
Purpose:
To view and configure the device via a LAN, you need to connect the network device in the same
subnet with your computer, and install the SADP or client software to search and change the IP of
the network device.
For the detailed introduction of SADP, please refer to Appendix.
2.1.1 Wiring over the LAN
The following figures show the two ways of cable connection of a network device and a
computer:
Purpose:
To test the network device, you can directly connect the network device to the computer
with a network cable as shown in Figure 2-1.
Refer to the Figure 2-2 to set the network device over the LAN via a switch or a router.
Network Cable
Figure 2-1 Connect Directly