User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
21
Chapter 3 Access to the Network
Device
You can access to the device by using web browser or client software. Here is the introduction of
accessing by web browser.
Steps:
1. Open the web browser.
2. In the address field, input the IP address of the network device, e.g., 192.168.1.64 and press
the Enter key to go to the. login interface.
3. Activate the device for the first time using, refer to the section 2.1.2 Activate the Device.
4. Select English as the interface language on the top-right of login interface.
5. Input the user name and password and click .
The admin user should configure the device accounts and user/operator permissions properly.
Delete the unnecessary accounts and user/operator permissions.
The device IP address gets locked if the admin user performs 7 failed password attempts (5
attempts for the user/operator).
Figure 3-1 Login Interface
6. Install the plug-in before viewing the live video and operating the device. Please follow the
installation prompts to install the plug-in.
You may have to close the web browser to install the plug-in. Please reopen the web browser
and log in again after installing the plug-in.