User Manual

User Manual of Thermal Bi-spectrum Network PTZ Device
ii
Symbol Convention
The symbols that may be found in this document are defined as follows.
Symbol
Description
Provides additional information to emphasize or supplement important
points of the main text.
Indicates a potentially hazardous situation, which if not avoided, could
result in equipment damage, data loss, performance degradation, or
unexpected results.
Indicates a hazard with a high level of risk, which if not avoided, will
result in death or serious injury.
Safety Instruction
 The device should be used in compliance with local laws and electrical safety regulations. Refer
to the appropriate documentation for detailed information.
 The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra Low Voltage) and
the Limited Power Source (24 VAC/12 VDC). Refer to the appropriate documentation for
detailed information.
 DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
caused by overload.
 Make sure the plug is properly connected to the power socket.
 If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
power cable, and contact the service center.
 The installer and user are responsible for password and security configuration and its settings.
 Both internal and external grounds should be connected properly. (The cross section area of
the grounding wire must be no less than 4 mm2, and no less than that of the phase connector).
 Do not drop the device or subject it to physical shock.
 Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
 Do not aim the lens at the sun or any other bright light.
 When any laser equipment is in use, make sure that the device lens is not exposed to the laser
beam, or it may burn out.
 Do not expose the device to high electromagnetic radiation or extremely hot, cold, dusty, or
damp environments.
 Place the device in a dry and well-ventilated environment.
 Keep non-waterproof devices away from liquids.
 Keep the device in original or similar packaging while transporting it.
 A few device components (e.g., electrolytic capacitor) require regular replacement. The
average lifespan varies, so periodic checking is recommended. Contact your dealer for details.
 Improper use or replacement of the battery may result in explosion hazard. Replace with the
same or equivalent type only. Dispose of used batteries in conformance with the instructions
provided by the battery manufacturer.
 Never attempt to disassemble the device.
0505191090816