User Manual

User Manual of Thermal Bi-spectrum Network PTZ Device
51
The time of each period cannot be overlapped. Up to 8 periods can be configured for each
day.
6. Set the Alarm Actions for Motion Detection.
Click tab to go to the. Linkage Method interface.
You can specify the linkage method when an event occurs. The following contents are about
how to configure the different types of linkage method.
Figure 5-14 Linkage Method
Check to select the linkage method. Notify Surveillance Center, Send Email, Upload to
FTP/Memory/NAS, Trigger Alarm Output and Trigger Recording are selectable.
 Notify Surveillance Center
Send an exception or alarm signal to remote management software when an event
occurs.
 Send Email
Send an email with alarm information to a user or users when an event occurs.
To send the Email when an event occurs, you need to refer to Section Configure Email
Settings to set the Email parameters.
 Upload to FTP/Memory/NAS
Capture the image when an alarm is triggered and upload the picture to a FTP server.
You need a FTP server and set FTP parameters first. Refer to Section Configure FTP for
setting FTP parameters.
 Trigger Alarm Output
Trigger one or more external alarm outputs when an event occurs.