User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
52
To trigger an alarm output when an event occurs, please refer to Section 5.2.4
Configure Alarm Output to set the alarm output parameters.
Trigger Recording
Record a video when an event occurs.
You have to set the recording schedule to realize this function. Please refer to Section
5.1.1 Configure Recording Schedule for settings the recording schedule.
5.2.2 Configure Video Tampering Alarm
Purpose:
You can configure the device to trigger the alarm actions when the lens is covered.
Steps:
1. Go to the. Video Tampering settings interface :
Configuration > Event > Basic Event > Video Tampering
2. Select the channel to set the video tampering alarm.
Figure 5-15 Tampering Alarm
3. Check Enable.
4. Click tab to go to the. arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configure Motion Detection.