User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
59
If GPS information is required for
platform accessing?
Start
YES NO
Enable GPS of Position
Settings
Set the application scene
and zoom parameters.
Set the VCA resource to
Fire Detection
Enable Fire Detection
(Event > Dynamic Fire Source Detection)
If the PTZ function is supported by the
camera?
YES
END
NO
Enable Fire Detection Shield.
Enable the
patrol/park/linear scan.
Set the north as the
Initial Position
Enable the fire point in
the Local Settings.
5.3.1 Configure Initial Position
Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial position.
You can also customize the initial position according to your own demand.
If you connect the device to the system platform, the platform can mark all the fire positions.
Steps: