User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
60
1. Go to the. Position Settings interface:
Configuration > PTZ > Position Settings.
Figure 5-22 Position Settings
2. Set the compass parameters.
(1) Select PT Mode as Manual.
(2) Click the PTZ control buttons to find the north direction; you can also call a defined
preset and set it as the north direction.
(3) Click Set as North to save the position.
(4) Optionally, you can click Point to North to move the device to the north direction if the
north direction was once saved.
3. Set the sensitivity of Vandal-proof Alarm. The higher the value is, more easily the alarm will
be triggered.
4. Enable or disable the alarm uploading and alarm voice warning function.
5. Set GPS settings.
(4) Select Longitude-Latitude Mode as Manual.
(5) Select longitude and latitude as East or West according to the actual position.
(6) Input the value of longitude and latitude in three textboxes.
6. Click Point to North and save.
7. Go to the Initial Position Configuration interface:
Configuration > PTZ > Initial Position