User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
61
Figure 5-23 PTZ Configuration
8. Click the PTZ control buttons to find a position as the initial position of the device; you can
also call a defined preset and set it as the initial position of the device.
9. Click Set to save the position.
Call/delete an Initial Position:
You can click to call the initial position. You can click to delete the initial position and
restore the factory default initial position.
5.3.2 Configure Dynamic Fire Source Detection
Purpose:
When you enable this function and fire source or smoke is detected, the alarm actions will be
triggered. You can set different detection mode, fire source zoom mode, and so on.
Steps:
1. Enter Configuration>Advanced Configuration>System>VCA Resource Type to select Fire and
Smoke Detection as VCA Resource Type.
2. Go to the. fire and smoke detection interface:
Configuration > Event > Smart Event > Dynamic Fire Source Detection