User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Network Connection
- Chapter 3 Access to the Network Device
- Chapter 4 Basic Operations
- Chapter 5 System Configuration
- Chapter 6 VCA Configuration
- Chapter 7 Device Configuration
- 7.1 Configure Network Settings
- 7.2 Configure Video and Audio Settings
- 7.3 Configure Image Settings
- 7.4 Configure System Settings
- Appendix
User Manual of Thermal Bi-spectrum Network PTZ Device
80
Figure 5-43 Position Settings
6. Select Network or RS-485 from the dropdown list
7. Set the delay time (Range 2-200s).
8. Click .
5.5.12 Position and Vandal-Resistance Alarm Settings
Steps:
5. Go to the. Position Settings interface:
Configuration > PTZ > Position Settings.
The actual interface may vary from model to model.
Figure 5-44 Position Settings
6. Set the vandal-resistance alarm.
(4) Slide the bar to adjust the sensitivity of vandal-resistance detection.
(5) Check Upload Vandal-Resistance Alarm to upload the vandal-resistance alarm.
(6) Check Enable Vandal-Resistance Alarm Voice Warning to enable the voice warning of
vandal-resistance alarm.