User Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Panels and Connections
- Chapter 3 Getting Started
- Chapter 4 Decoder Configuration and Operation by Web Browser
- 4.1 Decoder Configuration
- 4.1.1 Checking Device Information
- 4.1.2 Configuring Time Settings
- 4.1.3 Configuring RS-485/RS-232 Serial Port
- 4.1.4 Configuring Basic Network Settings
- 4.1.5 Configuring DDNS Settings
- 4.1.6 Configuring Wi-Fi Settings
- 4.1.7 Configuring Stream Settings
- 4.1.8 Configuring Transparent Channel
- 4.1.9 Configuring Synchronous Output Settings
- 4.1.10 Configuring Personalized Settings
- 4.1.11 Managing User Account
- 4.1.12 Importing/Exporting Configuration Files
- 4.1.13 Maintenance
- 4.2 Setting Video Wall Layout
- 4.3 Configuring Decoding Output
- 4.4 Decoding Operation
- 4.1 Decoder Configuration
- Chapter 5 Decoder Configuration and Operation by Client Software
- Chapter 6 Display via Wi-Fi Connection
- Chapter 7 Appendix
HD Video and Audio Decoder User Manual
DS-6900UDI Decoder User Manual
32
Close the Window Figure 4-35
Configuring Decoding Output 4.3
Purpose
In the output list, there are two kinds of video output signals, respectively BNC and HDMI. You can
configure the resolution and output mode.
Configuring BNC Output
Click Video Wall Configuration to enter the corresponding interface. Right click one of the Step 1
BNC signal sources.
BNC Decoding Output Figure 4-36
Right click one of BNC signal sources and select Resolution Configuration to pop up the Step 2
interface as below.
Resolution Configuration Figure 4-37
Select the resolution from the LCD Resolution drop-down list. PAL and NTSC are selectable. Step 3
Check the checkbox of Batch Configuration to set the same configuration for other outputs Step 4
with same signal source.