How to configure motion detection recording in 96NI-ST series NVR Step 1: Click Menu> Camera Step 2: Input IP address, admin and password of IP camera to add it.
Step 3: Click Menu> Camera>Motion. Select camera, enable Motion detection, configure the Sensitivity and then click Full Screen. (After this configuration you can click Copy to copy it to other cameras.) Step 4: Click Rule to check that Schedule and Triggering channel are all right. (After this configuration you can click Copy to copy it to other cameras.
Step 5: Click Menu> Camera> Record>Encoding parameters, select a camera and then configure Main stream (Normal) and Main stream (Event) to same parameters. (Please kindly make sure that all parameters of normal and event are same for each camera.) Step 6: Click Menu> Camera> Record>Record Schedule. Select camera, enable Record Schedule and then click Edit.
Step 7: Enable All day, select Motion and then copy it to all week. Apply the change.
Step 8: Click Copy to copy the schedule to other cameras. And then apply the configuration.
First Choice for Security Professionals Hikvision Technical Support
