Quick Start Guide

Rev. 010918NA

1 I N S T A L L A T I O N ( c o n t i n u e d )

 Connecting PTZ to the DVR

Disconnect

pluggable block

from the

RS-485 terminal block.

2. Connect A+ on PTZ to D+ on terminal

block and B- on controller to D- on

terminal block.

3. Fasten stop screws.

4. Connect pluggable block back into

terminal block.

Make sure both the controller and

the

DVR are grounded.

Figure 1-6 Controller Connection A (Typical)

2 M E N U O P E R A T I O N

 Startup

Proper startup is crucial to extending the life of the DVR.

It is HIGHLY recommended that an Uninterruptible Power Supply (UPS) be used in conjunction with the

device. The Power light on the front panel should be red, indicating the device is receiving power.

1. Check that the power supply is plugged into an electrical outlet.

2. Press the Power button on the rear panel. The Power LED should turn blue. The unit will start.

 Activating Your Device

For the first-time access, you need to activate the device by setting an admin password. No operation is

allowed before activation. You can also activate the device via a Web browser, SADP, or client software.

Enter

the same password in the text

fields of Create New Password and

Confirm New Password.

2. In the IP Camera Activation text field,

enter the password to activate the IP

camera(s) connected to the device.

3. Click OK to save the password and

activate the device.

Click to see password text.

Click again to hide password.

Figure 1-7 Set Admin Password