User Manual

Network Video Recorder User Manual
174
Configure Email
Purpose
The system can send an Email to designated users when a specified event occurs, such as an alarm
or motion event is detected, or the administrator password is changed, etc.
Before You Start
The device must be connected to a local area network (LAN) that contains an SMTP mail server.
The network must be connected to either an intranet or the Internet depending on the location of
the e-mail accounts to send notification.
Go to System > Network > Advanced > Email.
Email Settings
Configure the following Email settings.
 Enable Server Authentication: Check to enable the function if the SMTP server requires user
authentication and enter user name and password accordingly.
 SMTP Server: The IP address of SMTP Server or host name (e.g., smtp.263xmail.com).
 SMTP Port: The SMTP port. The default TCP/IP port used for SMTP is 25.
 Enable SSL/TLS: Check to enable SSL/TLS if required by the SMTP server.
 Sender: The name of the sender.
 Sender's Address: Sender's Address.
 Select Receivers: Select the receiver. Up to 3 receivers can be configured.