User Manual

DS-72xxHUI-Kx, DS-72xxHQI-Kx Digital Video Recorder (DVR) User Manual
62 UM DS-72xxHUI-Kx, DS-72xxHQI-Kx 062817NA
For –K series DVRs, the analog and IP cameras support enabling
H.264+/H.265+ if the video encoding is H.264/H.265 for the main
stream.
After enabling H.264+ or H.265+, the Bitrate Type, Video Quality,
Max. Bitrate Mode, Max. Bitrate(Kbps), and Max. Bitrate Range
Recommend are not configurable.
If H.265+ is enabled, line crossing detection and region entrance
detection are not supported.
For IP cameras, H.264+ or H.265+ should be supported by the
camera and added to the DVR with HIKVISION protocol.
System will reboot to activate the new settings after enabling H.264+
or H.265+.
4. Click M
ore Settings to configure more parameters.
Figure 71, More Settings of Record Parameters


 Pre-record: The time to record before the scheduled time or event. For example, if an alarm
triggers the recording at 10:00, if the pre-record time is 5 seconds, the camera starts recording
at 9:59:55.


 Post-record: The time to record after the event or the scheduled time. For example, if an
alarm triggers the recording to end at 11:00, if the post-record time is 5 seconds, it will record
until 11:00:05.


 Expired Time: The time to keep the record files in the HDDs. Once exceeded, the files will be
deleted. The files will be saved permanently if the value is set to 0. The actual keeping time for
the files is determined by the capacity of the HDDs.


 Redundant Record: Enabling redundant record saves the record in the redundant HDD.


 Record Audio: Enable to record sound and disable it to record the video without sound.