User Manual

DS-73xxHUI-K4, DS-73xxHQI-K4, DS-90xxHUI-K8 DVR User Manual
UM DS-73xxHUI-K4 DS-73xxHQI-K4 DS-90xxHUI-K8 092017NA 146
• Multi-address Mode: The parameters of the two NIC cards can be configured
independently. You can select LAN1 or LAN2 in the NIC type field for parameter
settings.
• Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you can
select the Main NIC to LAN1 or LAN2. By this way, in case of one NIC card failure,
the device will automatically enable the other standby NIC card so as to ensure the
normal running of the whole system.
The valid value of MTU is from 500 to 1500.
If the DHCP server is available, you can check the checkbox of Enable DHCP to
automatically obtain an IP address and other network settings from that server.
If DHCP is enabled, you can check the checkbox of Enable DNS DHCP or uncheck it
and edit the Preferred DNS Server and Alternate DNS Server.
3. After having configured the general settings, click Apply to save the settings.
11.2 Configuring Advanced Settings
11.2.1 Configuring PPPoE Settings
Purpose
The DVR allows access by Point-to-Point Protocol over Ethernet (PPPoE).
1. Go to Menu > System Configuration > Network > PPPoE.
Figure 194, PPPoE Settings Interface
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name and Password for PPPoE access.
The User Name and Password should be assigned by your ISP.
4. Click Apply to save the settings.
5. After successful settings, the system asks you to reboot the device to
enable the new settings, and the PPPoE dial-up is automatically
connected after reboot.
6. You can go to Menu > Maintenance > System Info > Net
work interface to
view the status of PPPoE connection.