User Manual

-
Auto:If you select Auto, the port mapping items are read-only, and the external ports are set
by the router automacally.
-
Manual:If you select Manual, you can edit the external port on your demand by clicking to
acvate External Port Sengs.
Note
• You can use the default port No., or change it according to actual requirements.
• External Port indicates the port No. for port mapping in the router.
• The value of the RTSP port No. should be 554 or between 1024 and 65535, while the value of
the other ports should be between 1 and 65535 and the value must be
dierent from each
other. If mulple devices are congured for the UPnP™ sengs under the same router, the
value of the port No. for each device should be unique.
4. Enter the virtual server seng page of router; ll in the blank of Internal Source Port with the
internal port value, the blank of External Source Port with the external port value, and other
required contents.
Note
• Each item should be corresponding with the device port, including server port,
hp port,
RTSP port and hps port.
• The virtual server seng interface below is for reference only, it may be dierent due to
dierent router manufactures. Please contact the manufacture of router if you have any
problems with
seng virtual server.
Figure 12-5 Seng Virtual Server Item
12.6 Congure Port
You can congure dierent types of ports to enable relevant funcons.
Steps
1. Go to System → Network → Advanced → More Sengs .
Network Video Recorder User Manual
108