User Manual

Network Video Recorder User Manual
UM NVR v4.xx 111717NA 18
1.2 IR Remote Control Operations
The device may be controlled with the included IR remote control, shown in Figure 1-5.
Batteries (2 × AAA) must be installed before operation.
The IR remote control is set at the factory to control the device (using default Device ID# 255)
without any additional steps. Device ID# 255 is the default universal device identification number
shared by the devices. You may also pair an IR remote control to a specific device by changing the
Device ID#, as follows:
Pairing (Enabling) the IR Remote Control to a Specific Device (optional)
You can pair an IR remote control to a specific device by creating a user-defined Device ID#. This
feature is useful when using multiple IR remote controls and devices.
On the NVR:
Step 1 Go to System > General.
Step 2 Type a number (255 digits maximum) into the Device No. field.
On the IR Remote Control:
Step 1 Press the DEV button.
Step 2 Use the number buttons to enter the Device ID# that was entered into the device.
Step 3 Press the Enter button to accept the new Device ID#.