DS-K1F600-D6E Series Enrollment Station Quick Start Guide
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Legal Information Quick Start Guide ©2019 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved. About this Manual The Manual includes instructions for using and managing the Product. Pictures, charts, images and all other information hereinafter are for description and explanation only. The information contained in the Manual is subject to change, without notice, due to firmware updates or other reasons.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide YOU SHALL NOT USE THIS PRODUCT FOR ANY PROHIBITED END-USES, INCLUDING THE DEVELOPMENT OR PRODUCTION OF WEAPONS OF MASS DESTRUCTION, THE DEVELOPMENT OR PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES IN THE CONTEXT RELATED TO ANY NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF HUMAN RIGHTS ABUSES. IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Available Model Product Name Enrollment Station Model Description DS-K1F600-D6E Supports enroll face and card No. DS-K1F600-D6E-F Supports enroll face, fingerprint, and card No. Scan the QR code to get the user manual of enrollment station. Note that mobile data charges may apply if Wi-Fi is unavailable.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide or dispose of it at designated collection points. For more information see: www.recyclethis.info 2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal waste in the European Union. See the product documentation for specific battery information. The battery is marked with this symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg).
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into Dangers and Cautions: Dangers: Neglecting any of the warnings may cause serious injury or death. Cautions: Neglecting any of the cautions may cause injury or equipment damage. Dangers: Follow these safeguards to prevent serious injury or death.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide • The device cover for indoor use shall be kept from rain and moisture. • Exposing the equipment to direct sun light, low ventilation or heat source such as heater or radiator is forbidden (ignorance can cause fire danger). • Do not aim the device at the sun or extra bright places. A blooming or smear may occur otherwise (which is not a malfunction however), and affecting the endurance of sensor at the same time.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Contents Chapter 1 Overview .................................................................................................................... 1 Chapter 2 Appearance ................................................................................................................ 2 Chapter 3 Activation ................................................................................................................... 4 3.1 Activate via Device .......
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Chapter 1 Overview Introduction Figure 1-1 Product Appearance The enrollment station can realize multiple user information's enrollment on one device. It supports enrolling face picture, fingerprint (parts of the device model support), 13.56 MHz IC card No., and 125KHz ID card No. Features • • • • • • • • 3.97-inch LCD touch screen for face recognition, parameters configuration, live view, etc.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Chapter 2 Appearance Figure 2-1 Appearance Table 2-1 Appearance Description No.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide No.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Chapter 3 Activation You should activate the device before the first login. After powering on the device, the system will switch to Device Activation page. Activation via the device, SADP tool and the client software are supported. The default values of the device are as follows: • The default IP address: 192.0.0.64 • The default port No.: 8000 • The default user name (super administrator): admin 3.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide 3.2 Activate via SADP SADP is a tool to detect, activate and modify the IP address of the device over the LAN. Before You Start • Get the SADP software from the supplied disk or the official website http:// www.hikvision.com/en/ , and install the SADP according to the prompts. • The device and the PC that runs the SADP tool should be within the same subnet. The following steps show how to activate a device and modify its IP address.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Chapter 4 Enroll Administrator's Face After activation, you should enroll an administrator's face for further operation. The administrator can login the device backend to manage and configure data. Steps 1. After activation, tap OK on the pop-up window. You will enter the face enrollment page. Figure 4-1 Face Enrollment Page 2. Enroll the administrator's face. 1) Tap and follow the instructions to enroll the face.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Chapter 5 Enroll via Device 5.1 Enroll Face via Device Before You Start • Power on and activate the device. For details about the activation, see Activation . • Enable Face Required in after logging in the device backend. Steps 1. Tap on the initial page. 2. Optional: If you have added an administrator's face in and enabled Verify by Administrator in , you should verify the administrator's permission.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Note For details about face recognition, see Tips When Collecting/Comparing Face Picture . 5. Optional: Tap to edit the employee ID. 5.2 Enroll Fingerprint via Device Before You Start • Power on and activate the device. For details about the activation, see Activation . • Set fingers in Select Finger in after logging in the device backend. Steps 1. Tap on the initial page. 2.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide 4) Optional: Tap the enrolled fingerprint (in blue) and tap OK in the dialogue box to clear the enrolled data and enroll a new fingerprint. 5. Optional: Tap to edit the employee ID. 5.3 Enroll Card via Device Before You Start • Power on and activate the device. For details about the activation, see Activation . • Set Card Number per User and Card No. Length in after logging in the device background. Steps 1. Tap on the initial page. 2.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Appendix A. Tips When Collecting/Comparing Face Picture The position when collecting or comparing face picture is as below: Expression • Keep your expression naturally when collecting or comparing face pictures, just like the expression in the picture below. • Do not wear hat, sunglasses, or other accessories that can affect the facial recognition function. • Do not make your hair cover your eyes, ears, etc. and heavy makeup is not allowed.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Appendix B. Tips for Scanning Fingerprint Recommended Finger Forefinger, middle finger or the third finger. Correct Scanning The figure displayed below is the correct way to scan your finger: You should press your finger on the scanner horizontally. The center of your scanned finger should align with the scanner center.
DS-K1F600-D6E Series Enrollment Station Quick Start Guide Others If your fingerprint is shallow, or it is hard to scan your fingerprint, we recommend you to use other authentication methods. If you have injuries on the scanned finger, the scanner may not recognize. You can change another finger and try again.
UD16569B-A